Spica

The camera module for barriers, wing and sliding gates

Spica here assembled in the tube housing for barriers all kinds (utility-model patent)

Features Practical use Description, Details Source

The optimal solution for recognition!

Features

Spica has the best view!

Practical use

Direct mounting on the barrier beam
For the installation on barriers we have developed our Barrier bar design, it is the best way to open barriers by number plate recognition, German Utility model.
Fully assembled barriers camera
Direct mounting on the sliding or swing gates
At gates, a camera is required which deliver a very distortion free picture from the plate. The camera module Spica can be used in conjunction with our Pollux. Pollux has a special camera connector for this camera. The camera module has also an integrated plate lights. So is at night, a perfect number plate recognition possible.
Direct mounting on the garage gate
They have a garage with a controllable opening device. To increase the comfort you want the Gate will open automatically when you use one of your cars ancestors. Here too, the camera module is in conjunction with Spica Pollux our excellent.
Work area with 2.5 mm lens (on special request)
The sketch shows the workspace of the Spica-mini camera Using the 2.5-mm lens. The symbol must complete within be the shaded area. Here it was assumed, about the barriers that bar at a height of 90cm of Roadway is located. The mark is at a height of 45cm vehicle appropriate. The work area is thus a difference in height specified by 45cm. If the difference is less than 45cm enlarges the work area according to both sides. The plate may in the work area at an angle or something wrong lie.
Spica in the tube casing (here old version) protected from wind and weather mounted on beam

Description, Details

Distance range

Spica is standard, with a 3.6mm lens supplied, the recommended range of distance from camera to plate is 1m to 3m. For smaller distances in the range 0.6 m - 1.2 m can be installed on demand the camera with a 2.5mm lens be. In this case, is in the order indicated.

Assembly

Mount Spica on garages, turning or sliding gate so that the approaching vehicle number plates in the complete image appears. Spica is designed for easy installation at the gate. The Equipment should be installed and adjusted so that the to cognitive features approximately 20..50% of image width makes. The camera must not be mounted at an angle.

Connection to Pollux

You connect Spica to Pollux with our special connection cable. There are wires for Spica supply and the video signal to Pollux, also it is guaranteed that the number plate recognition module can control the special plate light for a sure recognition by night (German Utility model).

For both directions

Do you want on both sides of the barrier or gate attach a camera module, then also the major cable without effort possible. To do this, two mini-cameras and Cable-Y. For this case, a Double tube housing (see illustration below) available for barrier assembly.

Integrated plate light

The driveway in front of the camera module must not be especially illuminating, because Spica has a built-Plate light. The integrated plate lights will automatically activated when a vehicle approaches to the dark. It illuminates the plate up to a distance of about 3 meters sufficient from.

Supply unit

Spica is designed for DC operation and tolerated supply voltage range of 9V to 18V (DC). The Power supply for the camera of the Pollux about the Cable. Is on both sides of the connecting cable is a robust Connectors installed, simply plug together and just finished.

Stickers

Included with the camera Spica is a label set with left and right label to attach to the barrier beam mentioned.

(english version also available)

Source